Belden XLR Male-to-Female Cable, 10 Metre — Neutrik

Belden XLR Male-to-Female Cable, 10 Metre (Neutrik Connectors)

This is a finished 10 metre XLR male-to-female audio lead built on Belden cable stock and terminated with Neutrik XLR connectors. It is the standard microphone and balanced line lead format: XLR output to XLR input, the connection used between microphones and mixers, and between mixers, processors and powered speakers. Ten metres is the working length for stage boxes, front-of-house runs and studio-to-live-room links where a short patch lead cannot reach.

Key features

• Finished 10 metre XLR male-to-female lead
• Belden cable stock for the run
• Neutrik XLR connectors at both ends
• The standard microphone and balanced line format
• Suitable for stage, front-of-house and studio runs
• Balanced audio where the connected equipment is balanced

The universal audio lead

Three-pin XLR male-to-female is the most widely used connection in professional audio because it is robust, latching and balanced. This lead follows that format exactly, with Neutrik terminations, the connector brand most engineers specify by default, on Belden cable. Used between a microphone and a mixer input, or anywhere a balanced line-level signal travels, it carries a mono balanced signal when the equipment at both ends is balanced, which is what keeps long runs quiet.

Why 10 metres

Length is a working decision. Ten metres reaches from a stage position to a small stage box, across a hall from a lectern to a mixer at the back, or between a control room and a live room, without chaining shorter leads together. Chained leads add failure points and noise opportunities; one correct-length lead is the professional answer. Choose the length around the actual route, leaving service slack at each end without leaving coils of spare cable at the equipment.

Using it well

Turn the receiving channel down before connecting or removing the lead. Align the plugs, seat them fully and confirm the latch before raising gain. Enable phantom power only when the microphone and the complete path support it. Route the lead away from power cables where the layout allows, avoid crushing or tight bends, and listen for intermittent noise while gently checking the lead before the session starts.

One lead, fewer joins

Every join in a cable run is a place for a fault to live: a latch not fully home, a contact worn by years of plugging, an adapter forgotten in another bag. A single 10 metre lead removes those joins from the longest and most critical run in most small systems, the one between the sound source and the desk. That reliability, plus connectors that latch positively and cable stock made for repeated coiling, is what you are buying over a bargain-bin equivalent.

For microphones and balanced line signals over a 10 metre run, this Belden and Neutrik XLR lead is the standard-format, professional-grade answer.