MX XLR Male Black Connector

The MX XLR Male Black Connector is a 3-pin XLR male cable connector for building, repairing or extending audio and video cables. When a plug is damaged, a cable needs a new end, or a custom length is required, a quality connector is the part that decides whether the finished cable works first time and keeps working. The male XLR carries three pins in the standard layout used for balanced microphone and line signals, and its shell is built to take the handling of stage and studio work.

Why Choose MX XLR Male Black Connector?

Connectors fail more often than cable itself, because they take all the handling: plugging, unplugging, pulling and bending at the point where the wire meets the plug. The MX XLR Male Black Connector is made for that working life, with a body that grips the cable, a strain relief that spreads bending force, and contacts that seat firmly in their mating sockets. For repair work, that means a cable that was headed for the bin can be brought back with one connector and a few minutes of soldering or crimping, depending on the connector type. For new builds, it means the finished cable starts life with a connector you can trust.

When fitting any connector, check the pin or contact layout against the equipment it will serve before soldering, and test the finished cable at low volume before it goes into a live show or session. A few minutes of checking saves the embarrassment of a silent channel when the event starts.

Key Features

• Standard fit: The MX XLR Male Black Connector follows the standard dimensions for its connector type, so it mates with the matching sockets across brands.
• Secure cable grip: The body and strain relief hold the cable firmly, so pulls on the cable do not reach the solder joints or contacts.
• Firm, positive seating: Contacts seat fully in their sockets for a reliable signal without crackle from a loose fit.
• Repair and custom-build use: The MX XLR Male Black Connector suits cable repair, custom lengths and DIY audio and video projects.
• Durable construction: Built for repeated plugging and unplugging in stage, studio and installed use.
• Simple to fit: A straightforward connector for anyone comfortable with basic cable assembly and testing.

Best Suited For

This connector suits technicians, installers, musicians and studios that repair their own cables, build custom lengths, or keep spares for event work. It is also the right part for replacing a single damaged plug instead of throwing away a whole cable.

Setup and Connection Guide

Strip the cable end carefully, keeping the conductors intact and the shield tidy. Fit the connector parts onto the cable in the right order before soldering, because the shell cannot be added after the joints are made. Solder or crimp each conductor to its correct contact, checking the layout twice, then slide the shell and strain relief into place and tighten them so the cable is gripped firmly. Test the finished cable with a continuity check or at low volume before live use, and label the cable if it is part of a larger loom.

Frequently Asked Questions

Will this connector fit my equipment?

If your equipment uses the same connector type and gender named in the title, this connector will mate directly. Check the connector type, gender and pin layout before ordering.

Can I use it to repair a damaged cable?

Yes. Cut off the damaged plug, fit the MX XLR Male Black Connector to the good cable end, and test the repaired cable before it returns to service.

Do I need special tools?

Basic cable assembly tools are enough for most connector fitting: a stripper, a soldering iron and solder for solder types, and a tester or a low-volume listening check to verify the finished cable.

Technical Specifications

Use it with a matching cable run such as the MX XLR Male to Female Cable (1.5m).

Explore Related Products

Pair this connector with the MX XLR Male to Female Cable (1.5m) when a finished cable is needed alongside a repair part.